Vimar ELVOX 46235.020C - Cruise Setup

58
Graphic User Interface (GUI) for IP Speed Dome
EN
4-Pressiris–toswitchmenumodeandPTZmode.Andthensetthepositionofthepresetbyclickingthedirection
buttons.
5-Setthetitlebyclicking
or button.
6-Savethesetting.
4.4.2 Cruise Setup
GotoDomeFunction CruiseSetupmenuasbelow:
Inthisinterface,byprogrammingpresetsincruiselistinadvance,thesystemwillkeepcallingthosepresetsattheset
timeinsequencewhenexecutingcruisecommandsothatnon-stopmonitoringbetweenmultipleimportantpositions
canbeachieved.Settingstepsareasfollows:
1-Selectthecruisenumber.
2-Editthecurrentcruise.Thiscamerasupports8cruisesand16presetsforeachcruise.Goto“EditCurCruise”menu
asshownbelow:
Setthepresetandtime.Thepresetrangesfrom001to255andthedwelltimeisfrom05sto240s.
3-Runthecurrentcruise.Thecamerawillautomaticallykeeprunningaccordingtothecruiseyousetuntilnewcom-
mandisreceived.Thecorrespondingoperatinginformationwilldisplayonthescreenwhenthecameraisrunning.
4-SelectSTOREtosavethesetting.