Vimar ELVOX 46235.020C - Alarm Input; Alarm Out

68
Graphic User Interface (GUI) for IP Speed Dome
EN
5.4.2 Alarm Input
Tosetsensoralarm(alarminput)
1-GotoCong Alarm AlarmIntosetalarmtrigger.
- Setthealarmtype,alarmholdingtimeandsensorname.
- Enablealarm.
- Setalarmtriggeroptions.Thesettingstepsarethesamewiththatofmotiondetection.
Pleaserefertomotiondetectionchapterfordetails.
- Click“Save”tosavethesettings.
Iftherearemanysensors,youmayuse“Copy”buttontoquicklyapplysettingstoothersensors.
2.Setthescheduleofthesensoralarm.Thesettingstepsoftheschedulearethesamewiththatofmotiondetection.
Pleaserefertomotiondetectionchapterfordetails.
5.4.3 Alarm Out
1-GotoCong
Alarm AlarmOutmenuasshownbelow:
2-Selectalarmholdingtimeandalarmnameatthe“AlarmHoldingTime”and“AlarmOut”pulldownlistboxrespec-
tively.
3-Click“Open”totriggeralarmoutput.Click“Close”tostopalarmoutput.
4-Pressthe“Save”buttontosavethesettings.