Vimar ELVOX 46235.020C - Track Setup; Alarm Setup

60
Graphic User Interface (GUI) for IP Speed Dome
EN
4.4.5 Track Setup
GotoDomeFunction TrackSetupmenuasshownbelow:
ThisfunctionisusedtomemorizetheoperationtoPTZ,zoomandfocussothatrepeatingoperationprogresscanbe
realizedbyrunningtrack.SettingSteps:
1-Choosethetracknumber.
2-Editthetrack.Enterthetracksettingmenu.Click“Iris–“tostartrecordingtrack.Controlthedomemovementbydi-
rectionbuttonsandthensavethesetting.Eachtrackcanrecordupto180s.Ifthetimeexceeds180s,thesystemwill
automaticallysavetheoperationdataandreturntothepreviousmenu.Inaddition,360commandscanberecorded
foreachtrackatmost.Ifexceeding360commands,thesystemwillautomaticallysavetherst360commandsand
thenexitthecurrentmenu.Therecordingtimeisrelatedtotheoperatingfrequency.Themorefrequenttheoperation
is,theshorterthememorytimeis.
3-Select“RUNCURTRACK…”toperformthecommand.
4.4.6 Alarm Setup
GotoDomeFunction AlarmSetupasshownbelow:
SettingSteps:
1-SelectAlarmInNo.
2-Goto“EDITCURALARMIN”menuasshownbelow.
(ALARM IN CON):SetthealarminputtypetobeNormallyOpened(N.O.)orNormallyClosed(N.C.)accordingtothe
sensortype.
(ALARM IN MODE):ON,OFFandTIMEareoptional.
(ALARM CALL):Callthepresetyouneed.Whentherstalarminputhappens,thecamerawillautomaticallyswitch
tothispresettomonitor.
(OUTPUT ENABLE):SelectitON.Whenalarminputoccurs,thecamerawilloutputalarminformation.
Note:Ifthedomeisonthemenustateonanalarm,anycommandisnegative.