Vimar ELVOX 7559 - Installer Configuration and PIN Management

24
TAB: 7559
EN
Installer conguration
To access the installer menu , you must enter the 3-digit code (PIN). The (default) PIN is 100, but this can be edited as
described below. The PIN is entered using the following keys:
• T2
to change the digit highlighted in colour in the sequence 0 – 9 – 8 … – 2 – 1 – 0 …
• C
to cancel the last digit, provided that the cursor is on the second or third digit, otherwise use to return to
the user conguration menu.
• T3
to change the digit highlighted in colour in the sequence 0 – 1 – 2 … – 8 – 9 – 0 …
• T4
to conrm the selected digit, and after the third digit, if the PIN entered is correct, to access the installer
conguration procedure. If the PIN is not correct, you are returned to the user conguration menu.
Note: once the correct PIN has been entered and you have returned to the user menu, it will not be necessary to enter
the PIN again to access the installer menu, until the internal unit returns to standby mode.
Touch
Touch
Touch