Vimar ELVOX 7559 - Alert Configuration

59
TAB: 7559
EN
Alert Conguration
Use SaveProg to select some of the characteristics of the Alert function:
1. Enabling
a. Disabled (default)
b. Enabled
2. Polarity state active
a. Contact normally open (default)
b. Contact normally closed
3. Activation delay
a. 0.1 s (default)
b. 0.5 s
c. 1 s
d. 2 s
4. Signalling mode
a. None
b. LED associated to the T2 button (default)
c. Sound
According to the selected signalling type, apart from the rst, the timer is as follows:
STATE LED TIMER SOUND TIMER
The internal unit waits to receive the alert
from the switchboard
Flashing with a cycle of 0.5 s on
/ 0.5 s o󰀨
A 2 KHz tone for 0.2 s
The internal unit has received
conrmation of the receipt of the message
from the switchboard
Flashing with a cycle of 0.1 s on
/ 0.1 s o󰀨
A 1 KHz tone for 0.1 s