Vimar ELVOX 7559 - Professional Firm Function; Professional Firm Operation

56
TAB: 7559
EN
Professional Firm Function
The Professional Firm function is used to automatically activate the lock on receiving a call from any outdoor unit in the
system. The Professional Firm function in Art. 7559 is basic and has no time bands. It must have been enabled via the
installer menu, or from SaveProg, and can be activated or deactivated by the user. By default the Professional Firm
function is both disabled and deactivated.
Professional Firm Operation
The activation or deactivation of the Professional Firm service by the user are done in two ways, where enabled in the
installed menu
1) With a long touch of the LOCK
key. In particular, the function is the following, depending on the length of the
touch. If less than 5 s, the duration is calculated when the key is released:
DURATION EFFECT
From 0.4 to 2 s Lock actuation
From 2.1 to 5 s None, to avoid false manoeuvres
After 5 s Activation or deactivation of Professional Firm
The dead time between 2 and 5 seconds is needed to avoid false lock opening manoeuvres and at the same time allows
the actuation even if the touch remains for a short time.
The activated service is indicated by the internal unit speaker giving of a high frequency tone for 0.2 s. At the same time
the LED associated to the LOCK
key ashes and remains on for 0.2 s every 4 s.
The deactivated service is indicated by the internal unit speaker giving of a lower frequency tone for 0.2 s. At the same
time the LED associated to the LOCK
key goes out.
If this occurs while a door open message is indicated, the LED ashes inversely, i.e. it remains o󰀨 for 0.2 s every 4 s.
2) Alternatively, having entered the user conguration menu, it is possible to activate / deactivate the service using T1
which appears only once enabled by the installer.
ICON PROFESSIONAL FIRM
Disable
On
The enabling switches at each touch.
Once the Professional Firm function has been enabled and activated, when receiving a direct call from an outdoor unit,
after 1 s, the congured internal unit will send the calling outdoor unit the lock actuation message.
Note: the function is available only for direct calls, i.e. for the master unit. There is no relation with the fact
that the internal unit has been assigned a main or secondary ID. They are two separate concepts.
If the lock has been activated, when the outdoor unit receives the ringtone end message the internal unit automatically
terminates the call. It is possible to avoid the automatic termination of the call by excluding the SaveProg ag called
Autom.Lock End which is normally selected automatically when the Professional Firm function is enabled. If the Save-
Prog ag called End Quick. Call is active, the call is ended immediately after the lock actuation is conrmed, and not
on receipt of the ringtone end.
The following table summarises what stated above: