17
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Pan and tilt brakes
16 The pan and tilt brakes are operated by levers (2)(3) at the rear of the head. They are applied by pulling
the appropriate lever up and back and released by pushing the lever forwards. The brakes should be applied
whenever the camera is left unattended.
Pan and tilt drag
17 The pan drag adjustment knob (16) is mounted on the left-hand lower part of the main body. Tilt drag is
adjusted by a knob (18) mounted on the face of the tilt drag housing on the left-hand side of the head. The pan
and tilt drag adjustment knobs are multi-turn controls. Turn the knobs clockwise to increase drag and counter-
clockwise to decrease drag.
WARNING!: Use only hand force to adjust drag. Do not over-tighten. Always set pan
and tilt drag to minimum when head is not in use.
To Next Page
Loading...
