VIPA SLIO Series - Page 20

Chapter 1 Basics and Assembly Manual VIPA System SLIO
1-12 HB300E - PS-CM - Rev. 11/28
• For mounting turn all the locking lever of the head module to be mounted
upwards.
• To mount the head module put it to the left module and push it, guided
by the stripes, to the mounting rail.
• Turn all the locking lever downward again.
• Plug again the electronic module, which you have removed before.
3 4
5
• Remove if exists the wiring of the module group. More about this may be
found at "Wiring".
• Press the unlocking lever at the lower side of the just mounted right
module of the module group and pull it forward.
• Turn all the locking lever of the module group to be exchanged upwards.
1
Exchange of a
module group