Manual VIPA System SLIO Chapter 2 Power modules
HB300E - PS-CM - Rev. 11/28 2-5
The following figure shows the standard cabling of the power supply by
means of a bus coupler.
DC24V
0V
DC24V
0V
1
2
DC24V max. 10A
SysDC5V max. 3A
(1) DC 24V for power section supply I/O area (max. 10A)
(2) DC 24V for electronic power supply bus coupler and I/O area
As soon as the sum current of the power section supply exceeds 10A, the
power module 007-1AB00 is to be placed. When the power module is
placed, further modules may be placed besides the power module at the
backplane bus, whose sum current of the power section supply does not
exceed 10A. On this way the System SLIO may be expanded up to a
maximum of 64 modules. Please consider that the sum current of the
electronic power supply does not exceed the maximum of 3A.
With a sum current greater than 3A the LEDs may not be activated. Here
the power module with the order number 007-1AB10 is to be placed
between the peripheral modules.
007-1AB00
Sys DC 5V: ---
DC 24V: 10A
007-1AB00
Sys DC 5V: ---
DC 24V: 10A
DC24V
0V
DC24V
0V
DC24V max. 10A
SysDC5V max. 3A
DC24V max. 10A DC24V max. 10A
DC24V
0V
DC24V
0V
1
2
1 1
(1) DC 24V for power section supply I/O area (max. 10A)
(2) DC 24V for electronic power supply bus coupler and I/O area
Deployment
Expansion by the
power module
007-1AB00
To Next Page
Loading...
