31
© 2013 Directed. All rights reserved.
1. With the engine running, set the parking brake and release the
foot brake.
2. Press the
button, the parking lights will turn on and the Re-
mote start LED and On tones play on the remote control.
3. Turn the key to off, and remove it from the ignition, the engine
continues running for the programmed runtime.
4. Exit the vehicle and arm the alarm.
Note
For Pit Stop on manual transmission vehicles follow the di-
rections in the Manual Transmission Start (MTS mode) sec-
tion with the door open.
Manual Transmission Start (MTS mode)
When installed into a manual transmission vehicle, the system requires
that the MTS mode is properly set when parking. If MTS mode is not
properly set or is defeated after being properly set the system will not
start the engine.
1. With the engine running, press the foot brake then set the parking
brake and leave the engine running. For Pit Stop or Turbo Timer
mode (to leave the engine running after arming), open the driver
door.
2. Release the foot brake. As long as the engine is running there is
no time limit to perform this step.
3. Within 20 seconds of foot brake release, press any command
button on the remote, after 20 seconds return to Step 2 (For Turbo
Timer Mode, press the optional dash mounted activation button
or send the Timer Mode command.
4. The parking lights flash 5 times to confirm MTS mode enable and
the remote start activates the ignition outputs. The Remote Start
LED and On tones play to confirm.
To Next Page
Loading...
