30
© 2013 Directed. All rights reserved.
message will be sent to the remote controls. When the Remote
start runtime expires the engine shuts off, the Remote Start Off
message is sent to the remote control and the countdown timer
restarts. Smart Start is exited after the final start.
Note
The temperature and battery thresholds can be changed by
an authorized Directed dealer if a higher or lower threshold
is desired.
Temperature Reporting
During Remote start the vehicle interior is checked regularly for tem-
perature changes. If a change in temperature is detected this report
will be sent to the remote for display. Each time the remote receives
this report it will beep and display the temperature as described for
the Temperature Request in the Advanced Commands section Level 1.
Note
Temperature report must be turned on by an authorized Di-
rected dealer.
Remote Start Time-out Alert
During remote start a message is sent three minutes before and again
at one minute before the engine turns off. The
LED, Remote Start
LED flash and several tones play as an alert to reset the runtime if
desired.
Pit Stop Mode
To exit vehicle with engine running
The system keeps the engine running during short trips into the house
or convenience store. To perform Pit Stop:
To Next Page
Loading...
