33
© 2013 Directed. All rights reserved.
Remote Start Faults
For user safety, the system must be properly configured or remote start
will not activate. The Remote Start Fault output (
LED on and long
fault tone) may be caused by any of several configuration issues. If the
remote start fails to activate, refer to the following table for the com-
mand type and parking light flashes that will identify the configuration
issue and solution.
Flashes * Possible Fault Solution
5 Brake on Release foot brake
6 Hood open Close hood
7 After performing Remote Start
command - MTS not enabled
After performing Timer Start or
Smart Start command
Enable MTS mode
Check all Solutions
8 Toggle Switch off Turn switch on
None Alarm is triggered Disarm or reset alarm
* Refers to the number of parking light flashes.
To Next Page
Loading...
