32
© 2013 Directed. All rights reserved.
5. Turn Off and remove the key from the ignition switch, the engine
remains running.
6. Exit the vehicle, close all the doors and arm the system.
7. The engine turns off and after a few seconds, the Remote Start
LED and Off tones play to confirm. If the door is opened in Step
3 then the engine continues to run.
Turbo Timer Mode
The system keeps the engine running for the Turbo Timer runtime and
can be activated by remote control or optional dash mounted activa-
tion button.
1. With the engine running, set the parking brake.
2. Press the optional dash mounted activation button or perform
the Timer Mode command (for manual transmission vehicles see
previous MTS mode section).
3. The parking lights turn on and the remote start activates the igni-
tion outputs. The Remote Start LED and On tones play to con-
firm.
4. Turn Off and remove the key from the ignition switch, the engine
remains running.
5. Exit the vehicle, close all the doors and arm the system.
6. The engine runs for the Turbo Mode runtime.
Note
Turbo Timer must be turned on by an authorized Directed
dealer.
For Turbo Timer mode on manual transmission vehicles fol-
low the directions in the Manual Transmission Start (MTS
mode) section with the door open and in step 3 send the
Timer Mode command from the remote control.
To Next Page
Loading...
