© 2005 Directed Electronics—all rights reserved
3399
release
and ................operate............................Timer Mode
and ................operate ..........................Short Run/Turbo
timer
and ................operate............................Channel 4
and ................operate............................Channel 5
and and operate .........................rear defogger
and ................operate............................Channel 6
NNOOTTEE::
Refer to the Owner’s Guide for specific transmitter notifications and transmitter usage.
ssyysstteemm ffeeaattuurreess lleeaarrnn rroouuttiinnee
The System Features Learn Routine dictates how the unit operates. It is possible to access and change any of
the feature settings using the Valet/program switch. However, this process can be greatly simplified by using the
Bitwriter®. Any of the settings can be changed and then assigned to one of up to four transmitters. This feature
is called Owner Recognition. Each time that particular transmitter is used to disarm the system, the assigned
feature settings will be recalled. Owner Recognition is only possible when programming the unit via the
Bitwriter®.
If programming with the Bitwriter®, the learn routine can be locked or unlocked. If the learn routine has
previously been locked, it must be unlocked before proceeding with reprogramming the learn routine. This
must be done by using either Bitwriter® - this cannot be done manually with the Valet switch. If the learn routine
is locked, features cannot be changed.
To Next Page
Loading...
