EN - 13
4.2 ADJUSTING THE VOLUME
To change the volume of the styles, press and hold the [METRONOME/
STYLE] button, and simultaneously use the keys from A0 (minimum volume)
to F#1 (maximum volume). This can be done either before starting a style,
or while it is playing.
4.3 ADJUSTING THE TEMPO
To change the tempo of the styles, in a range of 25 – 250 bpm, press the [TEMPO -] button to slow down and
[TEMPO +] to accelerate. Pressing both buttons simultaneously will
reset the default value.
Furthermore, the keyboard can be used for the same purpose. Press
and hold [METRONOME/STYLE], then:
- C#5 to A#5: enter the exact value of the tempo.
The correspondence between key and tempo can be found in
chap. 10.
- B5: decrease the tempo by 10 units.
- C6: decrease the tempo by 1 unit.
- C#6: restore the default tempo.
- D6: increase the tempo by 1 unit.
- D#6: increase the tempo by 10 units.
4.4 ACTIVATE / DEACTIVATE STYLE INTRO AND ENDING
Style settings can be modified, so that the [START/STOP] button
immediately starts the Style from the accompaniment phase, and
that the Style ends without ending.
To change these settings, press and hold the [PLAY] and
[METRONOME/STYLE] buttons, then:
- F6: disable introduction and ending.
- F#6: enable introduction and ending.
4.5 CHORDS RECOGNITION SECTION
The instrument has two modes of chord recognition:
-
Full Keyboard Chord
ON, chords are recognized on the entire range of the keyboard, with any selected
mode
(Single, Dual
and
Split).
The chord is recognized as such when at least three keys are pressed at
the same time.
Chords recognition section
Melody section
Keep in mind that, when the Style is stopped, selecting a new Style will also reset its default tempo. This may
modify the previously selected tempo.
+
(off)
+
A0
( )
+
10
(-1)
0 - 9
To Next Page
Loading...
Need help?
General
