Example Jobs 115
© 2015 Vision Engraving Systems
After clicking on Select, the Vision software window will show only the color being sent to the engraver,
in this case, black. Make sure that Engravers Plastic(Engraving) is the material selected, and all options
are turned on in the Cut Toolbox, including Dry Run for this example file. Select the Engrave icon from
the Cut Toolbox to send the file to the engraver.
If there are multiple pages, the Page Selection screen will appear for you to choose which page(s) to
send to the engraver. In this example, the Current page will be sent by itself so that the cut file can be
sent afterward.
To Next Page
Loading...
