Vision MAX Pro - Direct Connection to Computer

Vision Max Pro User Manual12
© 2015 Vision Engraving Systems
2.2.1 Direct Connection to Computer
Direct Connection to Computer Using Crossover Cable
Once the machine is connected directly to your computer's network port with the crossover cable (the
gray colored cable), turn the machine on.The power switch for the Max Pro is located on the left rear of
the machine's base. Once the machine has initialized, plug the supplied Vision USB drive into an
available USB port on your computer.
NOTE - This installation is performed on a Windows 7 PC. For Windows XP, Windows 8, Windows 8.1
or Windows 10, the screens are slightly different.
The computer will recognize the USB drive
and the following screen will appear.
Select Continue without scanning.
Select Open folder to view files.