Vision MAX Pro User Manual

Example Jobs 137
© 2015 Vision Engraving Systems
Select Metals - Diamond Drag in the Tool Setup window. To verify that the graphics are located
properly, turn the Dry Run ON in the Cut Toolbox and send the job to the machine. Start the job and
check to make sure the graphics you are engraving are positioned properly with the Red Dot Laser
Pointer. Adjust either the machine's Home Position or the position of the graphics within the Plate Area
to correct the positioning. Resend the job to the engraver with the Dry Run turned OFF to engrave the
item.

Vision MAX Pro Specifications

General

Brand	Vision
Model	MAX Pro
Category	Engraver
Language	English