Optional Accessories 179
© 2015 Vision Engraving Systems
Edge Clamps
This clamp is designed to secure engraving materials from the top surface and avoids bowing in most
applications. This clamp will hold material thicknesses of .020, .032, .062, and .125 by rotating the
clamp and tightening a thumbscrew.
Corner Clamps
This clamp is designed to hold down square or rectangular plates. By lining up the “V” cut-out of the
clamp with the corner of the plate, the engraver is allowed maximum engraving space. It will hold
material as thin as 1/32”.
To Next Page
Loading...
