Vision Max Pro User Manual90
© 2015 Vision Engraving Systems
with an initial setting of 0.005 - 0.010 inches (0.12 - 0.25 mm). After the job has run for a short time,
press the Pause Button on the front panel, then adjust the micrometer for more or less depth,
depending on the whether the engraving is acceptable. Note - be careful not to set the depth of cut
greater than the material thickness. This will cut completely through the material and potentially cut into
the t-slot table. Press Start to resume engraving and to determine if the depth is appropriate.
To Next Page
Loading...
