Menus and functions
D-307084 PowerMaster-360R User's Guide 19
when the system is armed. It is also used to temporarily remove from service faulty zones that require repair
work or to deactivate a sensor if, for example, you are decorating a room.
Here you can set the Zone Bypass Scheme i.e. to scroll through the list of registered (enrolled) sensors to
your PowerMaster-360R system and to Bypass (deactivate) faulty or disturbed sensors (either READY or
NOT-READY) or to Clear (reactivate) BYPASSED zones (sensors).
Once you have set a Bypass Scheme you can use the following 3 options:
> To quickly review the bypassed zones – refer to section B.2.
> To quickly clear a bypassed zone i.e. to reactivate the bypassed zone – refer to section B.1.
> To repeat (recall) the last used zone bypassing scheme – refer to section B.3.
1. Zones will be bypassed throughout one disarm-arm period only. Disarming the system after arming
will suspend the entire bypassing scheme but you can recall and reuse it as described in section B.3.
2. Fire zones cannot be bypassed.
3. Carefully read the section titled "Additional information" according to the indicated references
1
etc. –
see table at end of section B.3.
REMEMBER – ZONE BYPASSING COMPROMISES SECURITY!
Enter the [USER SETTINGS] menu
1
, select the [SET ZONE BYPASS]
2
option and press .
The first zone, Z01, is displayed.
3
Click the or button until the display reads the zone you wish
to bypass (or clear bypass), for example, "Z04" for Zone 04. After several
seconds the LED on the respective device starts flashing indicating "it's me".
When the display reads the zone you wish to bypass press .
The display now reads [<OK> TO BYPASS].
5
To bypass the selected zone press
A "Success Tune"
☺
sounds and the updated zone status is now displayed
i.e. [
Z04: BYPASSED
].
8
B. To Clear a Bypassed Zone
Repeat steps 1 to 2 above.
To Next Page
Loading...
