Visonic PowerMaster-360R - Enabling and Disabling the Squawk Option; Programming the Scheduler

Menus and functions
D-307084 PowerMaster-360R User's Guide 37
B.13 Enabling and disabling the squawk option
The PowerMaster-360R system (and its wireless sirens) can be set to produce a short "Squawk" of audible
feedback to assist you when you use a keyfob to arm (1 beep) and disarm (2 beeps) the PowerMaster-360R
system.
 Here you can enable or disable the Squawk.

Carefully read the section titled "Additional information" according to the indicated references
1
etc – see
table at end of this section.
1.
SQUAWK
Enter the [USER SETTINGS] menu, select the [SQUAWK] option and press
.
1
Squawk ON 
The display shows the currently selected setting.
2
2.
or
Click the or button until the display reads the required
setting, for example, "Squawk OFF" and press the button to confirm.
Squawk OFF
3.
Squawk OFF 
A "Success Tune" ☺ sounds. The display confirms the saved setting, and
then returns to the User Settings menu, step 1.
3, 4
☺ Return to step 1
Additional information (section B.13)
1
For detailed instructions on how to select User Settings – refer to sections A.1 and A.2.
2
a. The display shows the currently selected setting (indicated by a

symbol), for example, [ Squawk ON ].
b. You can now enable (ON) or disable (OFF) the Squawk option using the or button.
3
The

symbol now appears next to the new selected option.
4
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).
B.14 Programming the Scheduler
The PowerMaster system can be enrolled with wireless input/output (I/O) expanders, which include PGM
outputs that can be used to open and close an electrically-controlled gate, or to control a preferred electrical
device via keyfobs or according to a programmable weekly time schedule.
Here you can schedule PGM outputs for up to 4 different ON/OFF time activations per any desired day or days
of the week. In addition, you can schedule a “Daily” schedule that applies to every day of the week. It is
recommended to complete the Scheduler table (placed at the end of this section) before programming the
Scheduler.

Carefully read the section titled “Additional Information” according to the indicated references etc. – see
the table at the end of this section.
1.
SCHEDULER
Enter the [USER SETTINGS] menu, select the [SCHEDULER] option and
press .
1
2.
PGM No. --
Select the PGM number 01 to 16. Press .
B. To Set the Day
2
Sunday
The 1
st
day of the scheduler is displayed.
3.
or
Click the or button until the display reads the day you wish
to schedule or "Daily", for example, "Tuesday".
2