Visonic PowerMaster-360R - Programming the Duress Code; Add and Delete Proximity Tags

Menus and functions
24 D-307084 PowerMaster-360R User's Guide
B.5 Programming the duress code
A. To program the duress code
Additional information (section B.5)
1
For detailed instructions on how to select the setting options – refer to sections A.1 and A.2.
2
The display shows the default duress code (2580).
3
Do not set the duress code the same as an installer or user code.
4
To end this session and to select other menu options or to quit programming – follow the instructions in
section A.2.
B.6 Add and delete proximity tags
A proximity tag may be assigned to each of the user codes 1-48 that can be used instead of the user codes to
perform a variety of functions, for example, arming, disarming, reading the event log, etc.
Whenever a user code is required you can simply present a valid proximity tag instead of entering the user
code on devices such as KP-141 PG2 or KP-160 PG2. Each tag should be assigned with a serial No. 1-48 that
corresponds to the User Code No. 1-48 and correspondingly enrolled in the system.
The partition authorization of the tags has a different authorization than the users.
 Here you can add (enroll) new proximity tags or delete tags as required.

Carefully read the section titled "Additional information" according to the indicated references
1
etc. – see
table at end of this section.
A. To add (enroll) a proximity tag
1.
PROXIMITY TAGS
Enter the [USER SETTINGS] menu; select the [PROXIMITY TAGS] option
and press .
1
2.
ADD NEW TAG
The display will read [ADD NEW TAG].
3
To begin the process of enrolling a new proximity tag, press .
3.
ENROLL NOW or
ENTR ID:xxx-xxxx
Present the proximity tag to the control panel within the timeout period.
4.
DEVICE ENROLLED
If enrollment was successfully completed, a "Success Tune" ☺ sounds and
the display reads [DEVICE ENROLLED] for a short duration and then
changes to read the tag's details.
4
☺ Go to step 5
5.
T01:Tag (Prox)
The display shows the allocated tag serial No (user No.), which is always the
first free number, for example: [T01:Tag (Prox)].
A duress alarm message can be sent to the monitoring station if you are forced to disarm the system. To initiate a
duress message, you must disarm the system using the duress code. By default this code is 2580.
1.
DURESS CODE
Enter the [USER SETTINGS] menu, select the [DURESS CODE] option and
press .
1
2.
DURESS CODE 2580
At the blinking cursor position, enter the Duress Code, for example, 6973.
2, 3
3.
DURESS CODE 6973
When the duress code you wish to program appears on the display, press
.
☺ Return to step 1
A "Success Tune" ☺ sounds. The display confirms the saved code.
4