Visonic PowerMaster-360R - Powerlink Parameters

Menus and functions
D-307084 PowerMaster-360R User's Guide 43
B.17 PowerLink parameters
*
The PLNK curr.params menu shows the current IP address, subnet mask, default gateway and current mode of
communication. The PowerLink information is for support purposes only.
 Here you can see the current IP address of the PowerLink and other relevant data.

Carefully read the section titled "Additional information" according to the indicated references
1
etc. – see
table at end of this section.
1.
PLNK curr.params
Enter the [USER SETTINGS] menu, select the [PLNK curr.params]
option and press .
1
2.
Curr.IP address
Displays the current PowerLink IP address.
xxx.xxx.xxx.xxx
3.
Curr.subnet mask
Displays the current PowerLink subnet mask.
xxx.xxx.xxx.xxx
4.
Current Gateway
Displays the current PowerLink default gateway.
xxx.xxx.xxx.xxx
5.
Current path
Displays the current PowerLink mode of communication.
Press the button repeatedly until the display shows the
required mode and press . Select from one of the following
options: LAN; Cellular; WLAN; None.
☺ Return to step 2
2, 3
Additional information (section B.15)
1
For detailed instructions on how to select the Setting Options – refer to sections A.1 and A.2.
2
To end this session and return to previous menu options, press the button.
3
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).
*
If the Broadband Module is not registered to the PowerMaster, this menu is not displayed.