Visonic PowerMaster-360R - Exiting the Event Log

Maintenance
52 D-307084 PowerMaster-360R User's Guide
READY 00:00
1.
ENTER CODE:_
2.
CODE
When the Keypad display reads [ENTER CODE: _], enter the current
master user code.
LIST OF EVENTS
The "Success Tune" will sound and the Keypad display will read [LIST OF
EVENTS]. (see Important Note!)
3.
Click the button. The latest event will be shown.
Z13 alarm
The event is displayed in two parts, for example, "Z13 alarm" then "09/02/10
3:37 P".
The two displays will be shown alternately until clicking again to
move to the next event or until the event log times out (4 minutes).
09/02/10 3:37 P
4.
Click the button as many times as necessary to read all the
required data.
Important Note! Entering an incorrect code 3 times in a row, and each next
retry, will initiate a 30-second penalty lockout of the keypad.
Attention: The system will not allow you to erase the event log. Only the
installer is authorized to view and perform this function.
Exiting the event log
1.
or
Click the or button from anywhere within the event log.
The Keypad display will read [<OK> TO EXIT].
<OK> TO EXIT
2.
Click the button.
READY 00:00
The system reverts to the normal operating mode.