Introduction
6 D-307084 PowerMaster-360R User's Guide
Keypad display
The keypad display shows the system status and events, time and date, programming instructions and also an
event log file which is accompanied by the date and time of each event. The normal display alternates with the
time and the system status, for example:
Screen saver mode
For security reasons, it is sometimes required to hide the status indication (Keypad and LED display) from a
potential intruder. If the Screen Saver option is enabled by the installer, then if no key is pressed for more than
30 seconds, the Keypad display shows “PowerMaster-360R” and the LEDs stops indicating any status. Pressing
any key resumes the normal status display. Pressing the Fire or Emergency keys will also initiate the Fire or
Emergency alarm.
If configured by the installer for additional security, the system will ask you to enter your user code as well
before resuming the normal display.
When partition is enabled, the installer can configure the system so that if no key is pressed during more than 30
seconds the date and time will appear on the Keypad display.
Proximity tags
The system responds to valid proximity tags enrolled in the system through remote devices with proximity tags
readers such as the KP-141 PG2 or KP-160 PG2. The proximity tag enables you to perform a variety of
functions without entering a user code, for example arming, disarming, access to event logs, etc. Whenever the
user code is required, you can simply present a valid proximity tag and perform the required operation without
the need to key-in the user code.
Users and codes
As a master User (User No.1) you require a 4-digit security code to control the system. Code 0000 is not
allowed. You can also authorize 47 other people to use the system by providing them with their own security
codes. Security codes are used mainly to arm and disarm the system or to access information that is restricted
to authorized users only. See Chapter 4, B.4 Programming User Codes for details.
In addition, you can obtain up to 32 multi-function portable keyfob transmitters that you can use to easily arm,
disarm and control the system without accessing the panel. Keyfobs work both inside and from outside the
premises. See Chapter 2 and Chapter 4, section B.7 Add or delete keyfob transmitters for details.
The Duress Code enables you to disarm the system using a special code that sends a silent alarm to the
monitoring station. See chapter 2 for details.
To Next Page
Loading...
