Visonic PowerMaster-360R - 4. Menus and Functions; Entering User Settings Menu

Menus and functions
16 D-307084 PowerMaster-360R User's Guide
4. Menus and functions
This chapter explains the user programming features of your PowerMaster-360R system and allows you to tailor
the PowerMaster-360R system to your specific needs. All menu operations are performed using the Keypad which
contains the alarm system’s control keys, numerical keypad and display.
The chapter is divided into two sections, as follows:
Part A – Describes how to enter or exit the User Settings menu and how to select the required options.
Part B – Describes how to execute the selected settings.
A.1 Entering the user settings menu & selecting an option
The following procedure describes how to enter and move within the user settings menu.
Detailed descriptions of the user settings options are provided at the end of the procedure.
To exit the user settings menu – see section A.2.

1. You can enter the "USER SETTINGS" menu only when the system is disarmed.
2. Carefully read the section titled "Additional information" according to the indicated references
1
etc. –
see table at end of this section.
A. To enter the USER SETTINGS menu
1.
READY 00:00
Make sure the system is disarmed and then press the button
repeatedly until the display reads [USER SETTINGS].
1
2.
USER SETTINGS
Press
ENTER CODE:

The screen prompts you to enter your user code or present your proximity
tag.
3.
CODE
Enter your User Code.
2
SET BYPASS
The display reads the first Setting option of the User Settings menu
[SET BYPASS].
3
B. To select an option
4.
SET BYPASS
Click the or button until the display reads the required
option, for example, "TIME & FORMAT".
or
5.
TIME & FORMAT
When the required setting option appears on the display, press the
button to enter the setting process.
Continue to the selected
setting option in B.1 - B.15
The remainder of the procedures for the selected setting options is provided
in sections B.1 to B.15.
Additional information (section B.1)
1
Display shown in disarm state when all zones are secured (00:00 or other digits show present time).
2
a. If you have not already changed your personal code number, use the default setting – 1111.
b. Master User has access to all User Settings options. Other users have access only to the Bypass options.
c. If you enter an invalid user code 3 - 5 times, the keypad will be automatically disabled for a pre-defined
period of time and the message WRONG PASSWORD will be displayed.
3
The bypass options will be displayed in the User Settings menu only if enabled by the installer. Otherwise, the
first User Settings option displayed will be [ USER CODES ].