Visonic PowerMaster-360R - Page 21

Menus and functions
D-307084 PowerMaster-360R User's Guide 21
Additional information (section B.1 – B.3)
1
For detailed instructions on how to select User Settings –refer to sections A.1 and A.2.
2
This menu is displayed only if "BYPASS" was previously enabled by the installer.
3
a. The STATUS to the right of the zone number indicates whether the zone is READY, NOT-READY or
BYPASSED.
b. In the example, the display reads [ Z01: READY ] alternating with [ Living Room ].
4
This display will appear only if PARTITIONING was previously enabled.
5
a. If the zone you selected is "not bypassed", the display prompts you to press [ <OK> TO BYPASS ]. However,
if the zone you selected is already "bypassed", the display prompts you to press [ <OFF> TO CLEAR ].
b. To cancel and return to the previous step press or
6
This menu is not displayed if Partition is enabled.
7
The display now prompts you to press [ <OK> TO RECALL ] i.e. to repeat the last used bypass scheme. To
cancel and return to the User Settings menu, press .
8
You can now repeat steps 2 - 5 to bypass or clear another zone. To end this session and to select other
menu options or to quit programming - follow the instructions in section A.2.
9
You can now select another option in the User Settings menu (see section A.1), or quit programming (see
section A.2).