Viva Solo - Function Menu

12
№.
Function option
Screen view
Parameter ranges
1
Metronome type
XX Beat
0,2··· 9
2
Tune
XX Tune
-
50··· +50
3
Reverb type
XX Revb Type
1~10
4
Reverb depth
XXX Revb Live
0~127
5
Chorus type
XXX Chr Type
1~8
6
Chorus depth
XXX Chor Live
0~127
Note:
If either [Function Menu] or +/- buttons are pressed for 3 seconds, the system leaves the
function menu.
Metronome type setting
1.Press the [Function Menu] button, (if needed repeatedly) until "Beat" appears on the
screen. You can now select the metronome beat indication by pressing the [- / +] buttons.
Setting Reverb type
1. Press the [Function Menu] button until "004 Rev Type" appears on the screen
2. You can now select the reverb type by pressing the [- / +] buttons. There are a total of 10
types of reverbs.
3. Pressing the [- / +] buttons at the same time restores the reverb type to the preset
value: 004
Setting Reverb depth
1. Press the [Function Menu] button, if any, repeatedly until " XXX Rev Lev" appears on
thescreen. You can now select the length of the reverb by pressing the [- / +] buttons, the
interval goes from: 0 ~127.
Pressing the [- / +] buttons at the same time restores the reverb length to preset value.
Setting chorus type
1. Press the [Function Menu] button until "003 Chr Type" appears on the screen
You can now select the chorus type by pressing the [- / +] buttons. There’s a total of 8
types of chorus type.
4.Pressing the [- / +] buttons at the same time restores the reverb type to the value: 003
Setting Chorus depth
1. Press the [Function Menu] button, if any, repeatedly until " XXX Chr Lev" appears on
thescreen. You can now select chorus depth by pressing the [- / +] buttons, the interval
goes from: 0 ~127.
2. By pressing the [- /+] buttons at the same time, the chorus is restored to preset value.