II. Pre-use preparation
Power supply requirements
1. Use with power supply:
Use the special power adapter that was packed with this keyboard. Insert the DC
connector from the power adapter into the DC connector on the keyboard, and then plug
the other end into the socket, and finally turn the keyboard on the power button.
Caution: When not using the keyboard, unplug the power supply from the power outlet.
2. Use with batteries:
Open the battery cover at the bottom of the keyboard and add 8 x 1.5V D batteries and
make sure that the polarity of the batteries should correspond to + & - the direction of
batteries marked under the battery cover. Attach the battery cover after installation.
Caution: Please replace all batteries at once when replacing the batteries. Do not use
different kinds of batteries, and do not mix new and old batteries.
Remove the batteries to avoid possible damage due to battery leakage if you do not use
the keyboard for a long time.
In/outs on the back
1.Using headphones:
Plug the headphone jack into the [HEADPHONE] connector on the back of the keyboard
The internal speaker system on the keyboard is now automatically disconnected.
To Next Page
Loading...