™
Page 57 of 81
6 Loc3-10Tx Transmitter
Use the Information button to navigate/exit back to the locate screen.
When in the Locate screen the status of the Link is displayed in the Status bar.
The various indications of the status are listed below:
No radio module or it is disabled (Always disable in the User Menu when not in use)
No link and no signal
No link and poor signal
No link but good signal
Is linked to the transmitter but signal is poor
Is linked to the transmitter with a good signal
TIP
While the Transmitter and Receiver are linked, changing the Receiver Frequency will automatically
result in a similar change to the Transmitter frequency, so there is no need to re-enter the menu
screen to change the Transmitter frequency remotely. The Frequency indicator will flash when
resetting or if an invalid frequency is requested.
If the Tx/Rx Radio link is not being used, make sure the receiver’s link is set to “Disabled” on both RX
and TX as the radio link will continue to search for the transmitter or receiver and may interfere with
the Bluetooth operation. Also, disabling when not in use will conserve battery charge.
To Next Page
Loading...
Need help?
General
