Vivotek FD8161 - Hardware Reset; Status Led

VIVOTEK
User's Manual - 5
DI/DO Diagram
Please refer to the following illustration for the connection method�
Status LED
The LED indicates the status of the Network Camera�
Item LED status Description
1
All LED light=> All LED unlight=> Steady Red =>
Steady Red + Blink Green once per sec�
System booting
2 Steady Red Power on; Network fail
3 Blink Green every 1 sec� Network works
4 Blink Orange/ Yellow every 0.15sec Upgrading F/W
5 Blink Red every 0�15sec Restore default
6
Press the reset button until all LEDs blink fast (0.15sec/time),
then free the reset button
Reset button for reset
Hardware Reset
12V
+12V
Digital output
PIN 1
Power+12V
PIN 2
Digital input
PIN 3
Ground
PIN 4
The reset button is used to reset the system or
restore the factory default settings� Sometimes
resetting the system can return the camera to
normal operation� If the system problems remain
after reset, restore the factory settings and install
again�
Reset: Press and release the recessed reset
button with a paper clip or thin object� Wait for
the Network Camera to reboot�
Restore: Press and hold the recessed reset
button until the status LED rapidly blinks� Note
that all settings will be restored to factory default�
Upon successful restore, the status LED will
blink green and red during normal operation�
Recessed Reset Button
Status LED
SD/SDHC Card
Slot
SD/SDHC Card Capacity
This network camera is compliant with SD/
SDHC 16GB / 8GB and other preceding
standard SD cards�