VIVOTEK
88 - User's Manual
PTZ > PTZ settings
This section explains how to control the Network Camera’s Pan/Tilt/Zoom operation�
There are two ways to enable the function:
1. Digital: Control the e-PTZ operation. It allows users to quickly move the focus to a target area
for close-up viewing without moving the camera physically� Please refer to below for detailed
instruction�
Advanced Mode
Digital PTZ Operation (E-PTZ Operation)
If you select “Digital“, the e-PTZ control settings section will be displayed as shown below:
Select Stream: Select stream #1 to set up the e-PTZ control. Please note that each stream can possess
its own preset and patrol settings� For detailed information about how to set up preset and patrol settings,
please refer to page 88�
2010/12/10 17:08:56
2011/12/10 17:08:56
To Next Page
Loading...
