Vixel 9000 series User Manual

Vixel 9000 Series Installation & Configuration Guide CHAPTER 6 Zoning
43
zoneset menu
To view the zoneset menu, type the following command from the Root Menu:
config zone wwn zoneset
Object names (for new or existing Zone Sets, Zones, or Members) must be enclosed
in quotes when specified.
Command Description
back
Displays the menu that is one level upwards.
show
Displays the name of the currently enforced Zone Set (if any)
and the current setting of the Default Zone State.
state
Sets the Default Zone State to either “Blocking” or “non-
Blocking.” This setting governs communicability of devices in
the fabric when no Zone Set is enforced. While “nonBlock-
ing” allows all devices in the fabric to see all other devices in
the fabric, “Blocking” does not allow any device to see any
other device. This setting does not affect fabric operation
when a Zone Set is enforced. Default value: “nonBlocking.”
zoneset
Displays the zoneset menu (for configuring Zone Sets).
zone
Displays the zone menu (for configuring Zones).
>config zone wwn zoneset
Menu
1) back - Go back
2) show - Show zone sets (Example: >show)
3) senf - Show enforced zone set (Example: >senf)
4) add - Add zone set (Example: >add "zone set 1")
5) delete - Delete zone set (Example: >del "zone set 1")
6) define - Define zones within zone set (Example: >define "zone set 1")
7) activate - Activate zone set (Example: >activate "zone set 1")
8) deactiv - Deactivate zone set (Example: >deactiv)
(config/zone/wwn/zoneset)>

Vixel 9000 series Specifications

General

Brand	Vixel
Model	9000 series
Category	Switch
Language	English