Vixel 9000 Series Installation & Configuration Guide CHAPTER 6 Zoning
44
While the command examples shown within the menu specify one or more object
names (in this case, an object is a Zone Set), you may enter just the command. If the
required object names are not specified when the command is entered, then you are
prompted either for the desired name or for selection of one or more objects from a
list of those available.
Command Description
back
Displays the menu that is one level upwards.
show
Displays all configured Zone Sets. When a Zone Set is selected
from this display, constituent Zones are shown. When a Zone
is selected, constituent Members are shown.
senf
Displays the currently enforced Zone Set (if any). When the
displayed (enforced) Zone Set is selected, constituent Zones are
shown. (The list of zones may reflect a zone merge operation
and thus be different than originally defined.) When a Zone is
selected, constituent Members are shown.
add
Adds (creates) an empty Zone Set with the name specified.
delete
Deletes (removes) the specified Zone Set.
define
Defines (configures) Zones within the specified Zone Set. Each
previously added Zone is displayed with a Y/N prompt. The
initially displayed value within the prompt reflects the current
status of the Zone in relation to the specified Zone Set.
activate
Attempts to activate the specified Zone Set.
To verify that the Zone Set is enforced, type the following com-
mand from the Root Menu: config zone wwn show or the
following command from the zoneset menu (config/zone/
wwn/zoneset): senf
deactiv
Deactivates the currently enforced Zone Set.
To Next Page
Loading...
General