VIZIO VA26L HDTV10T User Manual
Version 6/5/2008 43
www.VIZIO.com
Adjusting the TV settings
If you did not set up your HDTV for DTV / TV channels using the Initial Setup screens or if your setup has
changed, you can do so from the TV menu.
Tuner Mode
1. Press MENU on the remote control or the side of your HDTV, then press ► repeatedly until the
TV menu opens.
2. Press ▲or ▼ to select Tuner Mode, then press ◄ or ► to choose Cable or Antenna (Air)
depending upon which equipment you have connected to the DTV / TV Input.
3. Press EXIT to exit the OSD.
Auto Search
Your HDTV can scan for channels in your area and store the channel information in the channel list. If a
channel does not have a signal, your HDTV skips that channel. When you press CH ▲or CH▼, your
HDTV changes to the next channel in the channel list.
1. Press MENU on the remote control or the side of your HDTV, then press ► repeatedly until the
TV menu opens.
2. Press ▲or ▼ to select Auto Search, then press ►. The Auto Search screen opens and begins
searching for analog and digital channels.
3. When the channel search is complete, press EXIT to exit the OSD.
To Next Page
Loading...
