General instructions
Check the package for external damage and contact your distribution partner if the instruments
have visible defects. Check that the delivery is complete and corresponds to the delivery note.
This product is a precision measuring instrument. We would like to point out that you should take
due care when choosing the installation site and following these suggestions and instructions.
Before installing, check that the specification on the type label matches your application.
Please read through these operating instructions carefully before commissioning. Incorrect
operation, errors in comprehension and the consequences of these can lead to breakage of the
instrument or risk of personal injury.
Commissioning and maintenance must be carried out by appropriately qualified personnel. Proper
use of the products is a necessary precondition for their smooth operation.
Safety information
The instruments must not be used outside the specified operating limits
(See also section Technical Data)
Incorrect operation can lead to breakage of the instrument or risk of personal injury.
When using toxic media it is strongly advised not to use glass cylinder measuring instruments:
cylinder breakage and leaks can cause risk of personal injury
Shocks, e.g. caused by magnetic valves, should be avoided.
The measuring instruments must be used solely for the medium specified in the delivery note.
Media which differ from this may lead to impaired durability and therefore cause leakage
Using the manual
This manual contains information on the variable area flowmeters Q-Flow and V-100 and high-
precision control valves M-Flow.
Sections and paragraphs which only apply to a particular product group are marked as follows:
Variable area flowmeters Q-Flow
Variable area flowmeters V-100
High-precision control valves M-Flow
To Next Page
Loading...
Need help?
General