Table of contents
Page
1. Introduction.................................................................................................37
2. Explanation of symbols ..............................................................................38
3. Package contents .......................................................................................38
4. Intended use...............................................................................................39
5. Safety information ......................................................................................40
a) General information..............................................................................40
b) Operating location ................................................................................ 41
c) Handling and use ................................................................................. 42
6. Controls/display ..........................................................................................44
a) Device .................................................................................................. 44
b) Display symbols ................................................................................... 45
7. Operation....................................................................................................46
8. Operation....................................................................................................47
a) Switching between “CURRENT” and “FORECAST” mode ..................47
b) Switching the display indicators ........................................................... 48
c) Starting, using, closing setup mode ..................................................... 51
d) Setting the time .................................................................................... 52
e) Setting electricity tariff 1 and 2 ............................................................. 53
f) Setting the standby and low standby limit value ..................................54
g) Setting the CO
2
emissions ...................................................................55
h) Alarm in the event of overload .............................................................56
i) Delete mode “CLr”................................................................................57
j) Backlight...............................................................................................59
k) Resetting the energy cost meter .......................................................... 59
35
To Next Page
Loading...
