VOLTCRAFT SEM4500 - Intended Use

4. Intended use
The product is used to measure and display the power consumption of electrical
devices. The product is connected between the mains socket and the electrical
load and requires no additional installation. Operation is only permissible when
connected to an earthed household mains socket. The max. admissible power
rating of the connected load must not be exceeded (see chapter “Technical data”).
Two different electricity tariffs can be entered for cost calculation (e.g. for day/
night-time electricity).
Furthermore, the CO
2
emissions of your electricity tariff can be entered. The en-
ergy cost meter can then show how much CO
2
was produced while the connected
load was used (or how much CO
2
production was prevented when using electricity
from sustainable sourced compared to a normal electricity tariff).
The saved data can also be displayed when not connected to a mains socket
since in this case, the power is supplied by an integrated Supercap capacitor.
Theenergycostmeterisnotofciallycalibratedandthereforemustnotbeused
for billing purposes.
It may only be used in dry indoor locations. The product must not become damp
or wet.
Read the operating instructions carefully and store them in a safe place. Only
make this product available to third parties together with its operating instruc-
tions. Observe all safety information and other information in these operating
instructions.
Using this product for any purpose other than those described above may dam-
agethe product and result inashortcircuit,reorelectricshock.The product
mustnotbemodiedorreassembled!
This product complies with statutory, national and European requirements.
39