EasyManuals Logo

VOLTCRAFT SEM4500 User Manual

VOLTCRAFT SEM4500
Go to English
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
g) Setting the CO
2
emissions
Here, you can enter the CO
2
emissions per kWh. The value applicable to your
respective electricity tariff (for example 0.480 kg/kWh) can be found on your elec-
tricity provider’s website.
If you have an electricity tariff with 100% electricity from sustainable
resources, entering 0.000 kg CO
2
/kWh is not appropriate.
You can enter a value for the CO
2
emissions of a normal electricity tariff.
The energy cost meter then shows how much CO
2
is saved by using a
provider of energy from sustainable resources.
Depending on the power consumption, the energy cost meter shows the respec-
tive CO
2
emissions generated during operation of the connected load.
If you have set the standby limit value (see Chapter 8. f) before setting the CO
2
value, you can proceed directly to the next step.
Otherwise, setup mode must be started, see Chapter 8. c). Press the
button (7) three times to go to setting of the CO
2
value, see the next step.
Briey pressing the
button (3) several
times selects the input position for the CO
2
value(theselectedinputpositionashes).
Changetheashingvaluewiththe
button
(6) or button(7).Afterconrmingthelast
inputposition,thedisplaystopsashing.
If noindicator is ashing,you canjump to thenextsetting by brieypress-
ing the
(7) button or exit thesetup menuby briey pressing the
button (2).
55

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VOLTCRAFT SEM4500 and is the answer not in the manual?

VOLTCRAFT SEM4500 Specifications

General IconGeneral
BrandVOLTCRAFT
ModelSEM4500
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals