Engaging Lowspeed
1 Move the lever to neutral position.
2 Press the neutral button (N) to activate Lowspeed.
If the message “Lowspeed initierate” (A) followd by
the snail symbol (B) in the display the lowspeed
function is not ready. Normal gear shifting until Low-
speed is activated.
When Lowspeed is engaged “Lowspeed acti-
vated” (C) shows on the display.
3 Active Lowspeed is indicated by the snail symbol
on the display.
Delay in gear shifting may occur when Lowspeed is
active.
Disengaging Lowspeed
1 Move the lever to neutral position.
2 Press the neutral button (N) to disengage the low-
speed function.
The message “Lowspeed deactivated” (E) shows in
the dispaly.
Propeller Shaft Brake
In certain operational circumstances the propeller may
cause the propeller shaft to rotate when the engine is
stopped. This passive rotation is uncomfortable and
can be harmful to the reverse gear as its oil pump,
which is driven by the input shaft, will not operate when
the engine is stopped.
The propeller shaft may be allowed to rotate with a
stopped engine up to 6–8 hours. After this, the engine
must be started and run for at least five minutes for
lubrication and cooling of the reverse gear.
To Next Page
Loading...
