Instrument panels
26 Right hand instrument panel
(4) to unlock or enable the anti-theft control. The red function
LED flashes.
2 Enter the current code, press key (5), enter the current code
again and press key (5) again to confirm the programming
(both control lights light up for approx. 1 sec.).
3 Enter the new code, press key (5), enter the new code again
and press key (5) again to confirm programming of the new
code (both control lights light up for approx. 1 sec.).
Factory code
– If both codes are unknown, or have been inadvertently edited,
you must inform the customer service department of Volvo
about the serial number of the machine, so that the anti-theft
device can be deactivated.
– After validation you will receive the auxiliary code, which ena-
bles you to delete both programmed codes. After this you can
again individually program one or two codes.
3 Ignition switch
The ignition switch is used for preheating and starting. The ignition
switch has three positions:
1 Stop position
2 Running position (activation of electric system)/
Preheating position
3Start position
1
2
3
1
Code (cur-
rent) +
Unlocking or
enabling the
anti-theft devi-
ce.
2
Code (cur-
rent) +
Preparing the
anti-theft devi-
ce to change
the code.
Code (cur-
rent) +
3
Code
(new) +
Setting the new
code for the
anti-theft devi-
ce.
Code
(new) +
#
#
#
#
To Next Page
Loading...
