Special tools
Note. If necessary, the workshop should be equipped with 2 deep (minimum 80 mm) hexagonal sockets, 22 mm and
27mm, for removing the injectors. These sockets can be obtained from a well stocked tool supplier and are not
stocked by Volvo Penta.
885224-6
Engine fixture. The tool should be supplemented with 4 pcs pin
screws 479971-4, 4 pcs nuts 971095-5, 4 pcs screws 970964-3
(
M10x140), 4 pcs screws 955311-6 (M8x140), 4 pcs washers
960148-5 (M10), 4 pcs washers 960141-0 (M8) and the arms
from engine fixture 885050-5.
9992520-8
Overhaul stand
856927-9
Measuring plastic (disposable item)
9510060-8
Multimeter
1
8
10
OF)
9999179-6
Key for dismantling of fuel and oil filters.
885251-9
Adapter for measuring compression pressureMD2030
.
885252-7
Adapter for measuring compression pressure
MD2010
,
MD2020
and
MD2040
.
To Next Page
Loading...
