Ceramic Master Е1000 en v3 10
DESCRIPTION OF PARAMETERS IN ORDER OF THEIR
APPEARANCE
IDLE TEMP
PREDRY TIME
ENTRY TEMP
DRY1 TIME
DRY2 RATE
DRY2 TEMP
DRY2 TIME
FIRE1 RATE
FIRE1 TEMP
FIRE1 TIME
FIRE2 RATE
FIRE2 TEMP
FIRE2 TIME
the temperature in IDLE mode. This is the temperature
which the furnace keeps in STOP mode when the muffle
is closed. Its value is from 150°C to 600°C but it can’t
exceed (ENTRY TEMP-20)°C. If the muffle is opened the
temperature inside is 150°C.
during this time the table stays in lower end position
when the temperature in the chamber is equal to
DRYTEMP. It can be changed from 0 s to 1 h.
starting temperature. This is the temperature which
must be reached in the furnace firing chamber before the
table starts moving upward after the start of the
program. Its value is from 325°C to 750°C.
the time for moving the table from lower end position to
the medium position which is about 1,5cm from the
upper end position of the table. It can be changed from
0s to 1h.
increase rate of the temperature at a medium position of
the table. Its value is from 30°C /min to 200°C /min. This
parameter can be skipped.
drying temperature at a medium position of the table. Its
value is from the value of parameter ENTRY TEMP °C to
the value of parameter (FIRE1 TEMP – 20)°C. This
parameter can be skipped.
time for maintaining of the drying temperature at a
medium position of the table. It can be changed from 0 s
to1 h. This parameter can be skipped.
increase rate of the temperature for first firing. Its value
is from 30°C /min to 200°C /min. This parameter can be
skipped.
the temperature for the first firing. Its value is from the
value of parameter (DRY2 TEMP + 20)°C to the value of
parameter (FIRE2 TEMP – 20)°C. This parameter can be
skipped.
time for maintaining the firing temperature FIRE1 TEMP.
It can be changed from 0s to 1h. This parameter can be
skipped.
increase rate of the temperature for second firing. Its
value is from 30°C /min to 200°C /min.
temperature for the second firing. Its value is from the
value of parameter (FIRE1 TEMP + 20)°C to 1200°C.
time for maintaining the temperature FIRE2 TEMP. It can
be changed from 0s to 1h.
To Next Page
Loading...