by thorough cleaning, apply the new wax
following the manufacturer’s instructions.
Allow the wax to dry completely, then
polish the floor with the waxing brushes,
turn over the Module and use the polishing
pads to give the floor its final gloss.
Polishing pads side
– These shine up
waxed surfaces
(FIGURE 11), whether hard
floor or parquet.
Do not use the appliance on wet
surfaces or outdoors.
Never run the Pulilux PL 515 over the
connecting cable or other cables lying on
the floor.
Do not use the Pulilux PL 515 with
inflammable waxes.
Stay away from rotating brushes of the
electronic brush.
Polishing with Kobolin
Remove the old wax coat, dirt and stains by
thoroughly washing the floor.
Spread the Kobolin
(FIGURE 12) wax
emulsion evenly on the clean and dry floor
using a humid cloth or a mop. Let the wax
emulsion dry well, at least 20 minutes and
preferably do not walk on the surface.
The Polishing-brushes (black discs) are used
on the dried Kobolin wax emulsion for a
rough polish and to remove excessive wax.
Polishing pads
– To achieve a better
optical effect and to obtain a glossy finish,
use the polishing pads and polish. One
square meter should be worked on for
about one minute, this also increases the
durability of the wax coating.
Tip: Kobolin wax emulsion can only be used
on water resistant floors; such as sealed
parquet, stone floors (marble, granite and
tiles), PVC-floors and linoleum. A bottle of
Kobolin can be used on appr. 330 m
2
sealed
parquet or stone floors, and for appr. 70 m
2
on PVC and linoleum floors.
FIGURE 12
FIGURE 11
Remove the brush unit by means of the
yellow ring (
FIGURE 6). Insert the required
brushes making certain that the selected
brushes are facing downward. Check that
all the protrusions fit snugly in their
respective seats.
Close the cowling of the Pulilux PL 515
until it locks and push the handle downwards
(FIGURE 7). Only use the handle for opening
the appliance, and never for carrying it.
Hard floor Module
Cleaning brush side Pulilux (FIGURE 8) with
cleaning brushes is highly effective for the
daily dry maintenance of most types of
hard floors such as tile, terracotta, porcelain
gres, clinker, rubber, etc. Their main feature
is their capacity to work even on floors that
aren’t perfectly flat, and with wide crevices.
Regular use stops the build-up of dirt in the
crevices and helps maintain the original
colour.
Power pad side
– These pads (FIGURE 9)
are extremely effective for removing dried-
on dirt and the opaque patina left after
traditional cleaning. They are perfect for
flat, non-waxed tiled or porcelain gres floors.
The PADS are not suitable for other
types of floor. Do not use them on metal or
fabric surfaces. Do not work on a single
point with the PADS for more than 3
seconds. Only the PADS are replaceable
(see
PAGE 36). Keep the Pulilux PL 515
moving when cleaning, and never stationary
when switched on.
Polishing module for waxed
and parquet floors
Waxing brush side (FIGURE 10) for polishing
waxed floors and for daily maintenance of
varnished parquet and linoleum floors.
To wax a floor, after removing the old wax
PL 515
71
PL 515
70
Assembly & Use Assembly & Use
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 6
To Next Page
Loading...
