GBR -8-
• Do not place explosive or ammable material in your fridge. Place drinks with
high alcohol content vertically in the fridge compartment and make sure their
tops are tightly closed.
Inalling and operating your fridge
Before using your fridge for the r time, please pay attention to the following points:
• The operating voltage for your fridge is 220-240 V at 50Hz.
• The plug mu be accessible after inallation.
• Your fridge may have an odour when it is operated for the r time. This is normal and
the odour will fade when your fridge arts to cool.
• Before connecting your fridge, ensure that the information on the data plate (voltage
and connected load) matches that of the mains electricity supply. If in doubt, consult a
qualied electrician.
• Insert the plug into a socket with an ecient ground connection. If the socket has no
ground contact or the plug does not match, we recommend you consult a qualied
electrician for assiance.
• The appliance mu be connected with a properly inalled fused socket. The power
supply (AC) and voltage at the operating point mu match with the details on the name
plate of the appliance (the name plate is located on the inside left of the appliance).
• We do not accept responsibility for any damages that occur due to ungrounded usage.
• Place your fridge where it will not be exposed to direct sunlight.
• Your fridge mu never be used outdoors or exposed to rain.
• Your appliance mu be at lea 50 cm away from oves, gas ovens and heater cores,
and at lea 5 cm away from electrical ovens.
• If your fridge is placed next to a deep freezer, there mu be at lea 2 cm between them
to prevent humidity forming on the outer surface.
• Do not cover the body or top of fridge with lace. This will aect the
performance of your fridge.
• Clearance of at lea 150 mm is required at the top of your appliance. Do
not place anything on top of your appliance.
• Do not place heavy items on the appliance.
• Use the adjuable front legs to make sure your appliance is level and able. You can
adju the legs by turning them in either direction. This mu be done before placing
food in the appliance.
• Clean the appliance thoroughly before use (see Cleaning and Maintenance).
• Before using your fridge, wipe all parts with a solution of warm water and a teaspoon of
sodium bicarbonate. Then, rinse with clean water and dry. Return all parts to the fridge
after cleaning.
• Inall using the plaic diance guides, which can be found at the rear of
the appliance. Turn 90 degrees (as shown in the diagram). This will keep
the condenser from touching the wall.
• Refrigerator should be placed again a wall with a free diance not exceeding
75 mm.