Vox StompLab IB User Manual

10
[Lo/Hi] and [Mid] are part of the [AMP/DR] parameter.
If [AMP/DR] is turned o, the eect will be disabled.
Also, you can set the volume level of the program with
the [AMP/DR] VALUE 2 knob (LEVEL).
For noise reduction, select [NR] with the CATEGORY
selector and adjust the sensitivity with the VALUE 1
knob. Adjust the noise reduction sensitivity so that you
don’t hear noise (hiss) when you’re not playing your
bass. Depending on the bass that you’re using, sustaining
notes may be cut o if you raise the noise reduction value
excessively. This parameter should be adjusted so notes
ring out naturally.
Eect/parameter type and parameter value display
In the Edit mode you can switch the eect names or the VALUE 1
and VALUE 2 values indicated with the Program UP/DOWN pedals.
The tuner

LED will light up when the eect name is indicated, the
tuner center LED will light up when VALUE 1 is indicated and the
tuner # LED will light up when VALUE 2 is indicated.
Checking the values saved in a program (Original
Value)
The Original Value LED in the program/value display lets you
check the parameter values of a saved program.
When you use the knob or buons to modify the value of a
parameter, the Original Value LED will light up when that value
matches the value that’s already been saved in the program (i.e.,
the original value).
In Program select mode, the Original Value LED will light up
if the values of all parameters match the values that are saved
in the program.
Saving a program — [WRITE]
Here’s how to save (write) a sound that you’ve created.
If you switch to a dierent program in Program mode or turn
o the power without writing your seings into memory, the
changes that you made will be lost.
1. Set the CATEGORY selector to [WRITE].
The program number will blink in the program/value display.
2.
Use the VALUE 1 knob or the / buons to select the program
location where you want to save your seings.
3. Press the  buon and  buon simultaneously for 1 second.
The program will be saved, and the program/value display
will indicate “ CP ” briey.
The newly saved program will overwrite (i.e., replace) the
existing seings, so the previous program in that location
will be lost.
To cancel saving the program, select a category other than
[WRITE] with the CATEGORY selector.

Vox StompLab IB Specifications

General

Brand	Vox
Model	StompLab IB
Category	Music Pedal
Language	English