Vox StompLab IB User Manual

11
Setting the type of device that you’ll be connecting
to the OUTPUT/PHONES jack and master volume -
[GBL] (GLOBAL)
You can set the type of device that you’ll be connecting to the
OUTPUT/ PHONES jack and the master volume of the StompLab.
These seings are common seings for all programs. The
type of device seing will be saved when the power is turned
o. When the power is turned o, the master volume will be
initialized at 7.0.
1. Select [GBL] with the CATEGORY selector.
2. Set the type of device that you’ll be connecting to the OUTPUT/
PHONES jack with the VALUE 1 knob.
This seing compensates the output from the bass amp model
so that it will be suitable for connection to the input jack of
your device.
A1: Use this seing if you’ve connected the StompLab to a
bass amp.
Ln: Use this seing if you’ve connected the StompLab to a
line input, to a headphones, to the power amp input of a bass
amp, or to a recorder.
3. Set the master volume with the VALUE 2 knob.
Restoring the factory preset programs
Here’s how to restore (reload) the StompLab’s programs back to
the original factory preset programs.
When you perform this operation, all of the programs you
created and stored inside the StompLab will be erased, and
replaced by the factory programs.
1. While holding down the  buon and the  buon, turn on
the power.
2. The program/value display will indicate “ rL ”, and the TUNER
# and

LEDs will blink. Take your hand o both buons you
had been pressing.
If you decide to cancel the reload operation at this point, press
the  buon.
3. If you wish to reload the factory seings press the  buon.
The program/value display will indicate “ Ld ” and reloading
will begin. When reloading has completed, the program/value
display will indicate “CP ”, and the StompLab will automatically
enter Program select mode.
Never turn o the power while reloading.

Vox StompLab IB Specifications

General

Brand	Vox
Model	StompLab IB
Category	Music Pedal
Language	English