6
Rear panel
1
2
3
4
1. INPUT jack
Connect your bass to this jack.
2. OUTPUT/PHONES jack
Connect this jack to your bass amp , mixer, recorder or headphones.
3. POWER button
To turn the power on or o, press and hold down this buon
for 1 second.
4. DC 9V jack
You can connect an optional AC adapter to this jack.
Setup
Installing batteries
Do not mix new baeries and used baeries or dierent types
of baeries together.
1.
Remove the 4 screws from the rubber feet that secure the
boom cover.
2. Insert four AA-size baeries, being sure to observe the correct
polarity (“+” and “-” markings), and close the boom cover.
If the baery level becomes low, noise may be generated.
Basic connections
Be sure to connect all cables with the power turned o. If you
fail to use caution when connecting cables, you could damage
your bass amp or speaker system, or cause other malfunctions.
1. Use a cable to connect the StompLab’s OUTPUT/PHONES jack
to your bass amp,mixer or recorder.
When connecting cables or turning on the power, make sure
to lower the volume of your amp or mixer so that you don’t
hear noise
If you’re using headphones, plug them into the OUTPUT/
PHONES jack.
If you’re using the optional AC adapter, connect it to the
rear panel DC9V power supply jack, and then plug the
adapter into an AC outlet to turn the power on.
2. Connect your bass to the rear panel INPUT jack.
3. Press and hold the power buon and release the switch when
the program/value display lights up.
When the StompLab starts, the program/value display will
indicate the program number.
4.
Raise the volume of your amp or mixer to the appropriate volume.
To Next Page
Loading...
Need help?
General
