Vox StompLab IB User Manual

12
Troubleshooting
If you suspect a malfunction, please check the following points. If
this does not resolve the problem, please contact a nearby dealer.
1. Power does not turn on
q Have the baeries have run down?
q When the baeries run low, the program/value display will
be dark. We recommend that you replace the baeries as
soon as possible. If baeries become unusable, remove them
immediately. Leaving drained baeries in the unit can cause
malfunctions (such as baery leakage). You should also remove
the baeries if you won’t be using the StompLab for an extended
period of time.
q Make sure the baeries are inserted with the polarities (+, -)
in the correct orientation.
q Is the AC adapter connected to the rear panel DC9V jack?
q Is the AC adapter plugged into an AC outlet?
q Could the AC adapter be damaged?
2. No sound
q Is the volume of your bass turned down?
q Is your bass cable connected correctly?
q Is your bass cable broken?
q Are the [AMP/DR] VALUE 1 (GAIN) or VALUE 2 (LEVEL)
parameters currently set to a low value?
q Are the [Lo/Hi] or [Mid] parameters currently set to a low value?
For some amp models, there may be no sound from the amp
if the LO, MID, and HI control values are low.
q Is the volume turned down for another eect?
q Is the Mute function activated?
Refer to “Bypass and Mute” (p. 8) and cancel the Mute function.
q Is the master volume turned down?
Set the CATEGORY selector to [GBL], and turn the VALUE 2
knob to adjust the master volume.
3. Eects don’t apply
q Could an eect be o?
q Is the [MOD] VALUE 2 knob (DEPTH) or the [DLY] or [REV]
VALUE 2 knob (MIX) set to a low value?
q Is the StompLab in Bypass mode?
Refer to “Bypass and Mute” (p. 8) and cancel the Bypass function.
4. High frequencies are distorted when using [PDL] (PEDAL)
AC (ACOUSTIC )
q Are you applying too much drive?
Lower the [AMP/DR] VALUE 1 (GAIN) seing.
q Are you using a bass that has high output humbucking pickups?
Lower the volume of your bass.
5. Sound source connected to the bass amp is distorted, or
sounds wrong
q Is the VALUE 1 knob (StompLab OUTPUT/PHONES jack
connection volume) in [GBL] set at Ln (LINE)?
Set to AP (AMP).
q Is the VALUE 2 knob (LEVEL) in [AMP/DR] or the VALUE 2
knob (MASTER LEVEL) in [GBL] set too high?

Vox StompLab IB Specifications

General

Brand	Vox
Model	StompLab IB
Category	Music Pedal
Language	English